• 歡迎訪問徐州開元稱重設備有限公司網站!我們銷售的不僅僅是產品,更是完整的汽車衡解決方案

    • 微信公眾號

    • 手機

    EN

    全國24小時服務電話:

    0516-89366777

    您的位置:首頁 - 新聞資訊 - Company news - Selection and installation attention of weighing module

    Selection and installation attention of weighing module
    發布時間:2018-6-1 17:55:54      點擊次數:1667

    (1) attention to selection of weighing module

    The selection of electronic weighing module is generally chosen according to the supporting point of the container to select the range of 3 one or 4 one set of modules. Due to the weight of the scale body (container), the vibration impact and the partial load, the following rules are generally chosen. Multi sensor static weighing system:

    The fixed load (weighing platform, container, etc.) + variable load (the load required to be weighed) is less than the rated load of the sensor * the number of sensors of the sensor by X 70%, of which 70% of the coefficient is taken into consideration of the factors of vibration, impact and partial load.

    (2) precautions for installation

    The weighing module should pay attention to horizontal adjustment, including the horizontal adjustment between the installation plane of a single module and a weighing module.

    When welding, the sensor can not pass through the current, and when the roof is welded, the ground wire should be connected to the scale body. When the floor is welded, the ground wire should be connected to the base to prevent the damage of the sensor.

    The weighing module, if there is a pipeline on the weighing body, should be replaced with a hose or a connection pipe as long as possible to prevent them from eating the real load of the sensor and causing errors.

    A weight check table should be welded on the container for verification. Containers are usually placed without weights, and a platform is needed for placing weights. Usually, it is welded below the container to facilitate placing weights up and down.

    The junction box must pay attention to moistureproof, and the excess hole should be blocked with a sealing plug. If the junction box is installed outside, the protective box must be added to prevent rain. The failure of the junction box due to the damp of the junction box often occurs, so we must pay enough attention to it.

    上一條:Replacement method of electronic scale sensor
    下一條:Selection principle of sensor

    返回列表

    推薦產品

    RECOMMENDED PRODUCTS

    聯系我們

    CONTACT US

    徐州開元稱重設備有限公司

    電話:0516-89366777

    傳真:0516-89366777

    手機:15162290006

    郵箱:xzkyhq@163.com

    網址:xzkycz.com

    地址:江蘇省徐州市鳳城開發區龍霧橋西

    相關新聞

    RELATED NEWS

    人妻在线日韩免费视频